📋 Quick Facts — Plumbing Permit in Memphis
| Detail | Info |
|---|---|
| Permit Required? | Yes — in most cases |
| Permit Type | Plumbing Permit |
| Permit Office | City of Memphis Division of Construction Code Enforcement |
| Phone | (901) 636-6480 |
| Hours | Mon–Fri 8am–5pm |
| Online Portal | Apply Online |
| Fee / Timeline | Current Data |
|---|---|
| Plumbing Permit Fee | $75 flat estimated. |
| Approval Time | 1–5 business days |
| NEC Edition (TN) | 2017 |
| Permit Authority | Statewide — Tennessee Building Commission |
Do I Need a Plumbing Permit in Memphis?
The short answer: almost always yes. REQUIRED for any work on a plumbing system beyond simple fixture replacement — and Memphis is no exception. The City of Memphis Division of Construction Code Enforcement enforces plumbing permit requirements for residential and commercial work.
✅ Work That Always Requires a Permit
- Water heater replacement (gas or electric)
- New plumbing rough-in (new supply and drain lines)
- Moving existing plumbing supply or drain lines
- Adding new plumbing fixtures (sink, toilet, shower)
- Water service line replacement
- Sewer lateral repair or replacement
- Gas line work (new or modification)
⚠️ Work That May Be Exempt
- Replacing a faucet on an existing supply line (no pipe work)
- Replacing a toilet on existing rough-in (some jurisdictions)
- Clearing a drain clog (maintenance work)
💰 Plumbing Permit Fees in Memphis (2026)
Permit fees in Memphis are set by City of Memphis Division of Construction Code Enforcement. Here's the current fee structure for plumbing work:
| Fee Item | Amount |
|---|---|
| Plumbing Permit | $75 flat estimated. |
Verify with Memphis Construction Code Enforcement — (901) 636-6480. Tennessee 2017 NEC statewide. TN TDCI contractor licensing.
* Fees may change. Always verify current rates with City of Memphis Division of Construction Code Enforcement at https://www.memphistn.gov/government/planning/construction-code-enforcement.
🔍 Inspection Requirements
After the permit is issued, Memphis requires inspections at key stages. Do not cover work before it's inspected.
- Rough-in Inspection: Inspector checks all supply and drain lines before walls are closed. Pipe material, slope of drain lines (1/4 inch per foot minimum), proper venting, and water test.
- Final Inspection: Verifies all fixtures are installed and functioning, water heater is properly vented and strapped, T&P valve discharge is correct, no leaks.
📝 How to Apply for a Plumbing Permit in Memphis
- Verify your contractor is licensed — Licensed plumber (state-specific license) in most states. Some states allow homeowners for owner-occupied single-family homes. Plumber's license required in CA, FL, TX, NY, IL, PA, and most major states..
- Gather required documents — Equipment specs, site plan, load calculations where applicable.
- Submit the application — Online at City of Memphis Division of Construction Code Enforcement or in person.
- Pay the permit fee — $75 flat estimated..
- Post the permit — Keep a copy on-site until all inspections pass.
- Schedule inspections — Do not cover work until the inspector signs off.
📌 Tennessee State Requirements
In addition to Memphis's local rules, these state-level requirements apply:
- Nashville: own Metro Codes Department — active enforcement, good online portal
- Memphis: own codes office
- NEC 2017 — older electrical code
- TN Department of Commerce & Insurance — licensing
🚫 Common Plumbing Permit Mistakes in Memphis
- Skipping the permit on water heater replacement — most common unlicensed plumbing violation
- Wrong T&P valve discharge pipe material (CPVC not allowed in some jurisdictions — must be copper or galvanized)
- Missing expansion tank on closed systems (required when backflow preventer is present)
- Not strapping water heater in seismic zones
💡 Pro Tips from Contractors
- Water heater permits are usually same-day, over the counter — takes 15 minutes to pull
- In CA: seismic strapping is strictly enforced — both upper and lower straps required, specific heights
- Gas water heaters need B-vent inspection before firing up — confirm with inspector
- In most cities, you can pull the permit online same day — no need to go to the building department
Notes specific to Memphis:
- Tennessee 2017 NEC (older edition)
- TN TDCI contractor licensing
- Second-largest city in TN
- Accela online portal
Get Your Exact Plumbing Permit Requirements in 5 Seconds
Our AI searches live building department data for Memphis and all 50 states — returning the exact permit requirements, fees, and application links for your job. No hold music. No guessing.
Run a Free Permit Check →❓ Frequently Asked Questions
Do I need a plumbing permit in Memphis, TN?
Yes, in most cases. REQUIRED for any work on a plumbing system beyond simple fixture replacement. In Memphis, contact City of Memphis Division of Construction Code Enforcement at https://www.memphistn.gov/government/planning/construction-code-enforcement.
How much does a plumbing permit cost in Memphis?
In Memphis: $75 flat estimated.. Fees may change — always confirm with City of Memphis Division of Construction Code Enforcement before applying.
How long does a plumbing permit take in Memphis?
1–5 business days. Simple residential trade work is often issued same-day or within 1–3 business days.
Who can pull a plumbing permit in Tennessee?
Licensed plumber (state-specific license) in most states. Some states allow homeowners for owner-occupied single-family homes. Plumber's license required in CA, FL, TX, NY, IL, PA, and most major states.