🪵 Deck Permit in Aurora, CO

📋 Quick Facts — Deck Permit in Aurora

Do I Need a Deck Permit in Aurora?

The short answer: almost always yes. REQUIRED for most deck additions over 200 sq ft or 30 inches above grade — and Aurora is no exception. The City of Aurora Building Division enforces building permit requirements for residential and commercial work.

✅ Work That Always Requires a Permit

• Attached deck over 30 inches above grade at any point
• Deck over 200 square feet (most jurisdictions)
• Deck attached to the structure of the house
• Deck with roof, pergola, or covered structure
• Deck with electrical (outlets, lighting circuits)

💰 Deck Permit Fees in Aurora (2026)

Permit fees in Aurora are set by City of Aurora Building Division. Here's the current fee structure for deck work:

VERIFIED: Aurora uses permit fees + plan review + applicable taxes (auroragov.org). Fee calculator: auroragov.org/business_services/building_division/permit_fee_calculator. Aurora requires separate mechanical contractor licensing through city building dept.

* Fees may change. Always verify current rates with City of Aurora Building Division at https://www.auroragov.org/business_services/building_division.

🔍 Inspection Requirements

After the permit is issued, Aurora requires inspections at key stages. Do not cover work before it's inspected.

• Footing Inspection: Inspector verifies hole depth reaches below frost line, correct diameter, and placement before concrete is poured.
• Framing Inspection: Inspector checks ledger board attachment, joist hangers, post sizing, beam sizing, and connection hardware.
• Final Inspection: Guardrail height and spacing (4-inch balusters, 36-42 inch rail height), stair rise/run, all fasteners in place.

📝 How to Apply for a Deck Permit in Aurora

1. Verify your contractor is licensed — Licensed General Contractor or specialty contractor. Homeowner can pull in most jurisdictions for owner-occupied single-family homes..
2. Gather required documents — Equipment specs, site plan, load calculations where applicable.
3. Submit the application — Online at City of Aurora Building Division or in person.
4. Pay the permit fee — VERIFIED: Aurora uses permit fees + plan review + applicable taxes (auroragov.org). Fee calculator: auroragov.org/business_services/building_division/permit_fee_calculator. Aurora requires separate mechanical contractor licensing through city building dept..
5. Post the permit — Keep a copy on-site until all inspections pass.
6. Schedule inspections — Do not cover work until the inspector signs off.

📌 Colorado State Requirements

In addition to Aurora's local rules, these state-level requirements apply:

• Denver has its own permit system — Denver Community Planning and Development
• Colorado Springs, Fort Collins, Boulder all have own permit offices
• Mountain towns (Aspen, Vail) — very strict, slow permit process, high fees
• Front Range: Class 4 hail-resistant roofing common due to insurance requirements

→ Colorado Licensing Board

🏗️ Why Contractors in Aurora Use PermitAssist

• Skip the hold music: Aurora's City of Aurora Building Division is busy — AI research takes 30 seconds vs. 30–45 minutes on hold or waiting for a callback.
• Know before you bid: Include exact deck permit costs in estimates before the job is won — no surprise fees eating into your margin.
• Multi-city Colorado coverage: If you work across Colorado, get permit requirements for every AHJ in one tool — no per-city learning curve.
• Avoid the $2K–$10K mistake: One stop-work order costs more than years of PermitAssist. Know the deck permit rules before you start — every time.

🚫 Common Deck Permit Mistakes in Aurora

These are the most frequent errors contractors make when pulling deck permits in Aurora and the surrounding Colorado area:

• Not opening footing holes for inspection before pouring concrete — major fail
• Ledger board attachment not properly flashed — #1 deck failure point
• Using non-approved hardware (galvanized vs stainless in coastal areas)
• Guardrail balusters too wide — 4-inch sphere rule strictly enforced

⚡ PermitAssist vs. Calling Aurora Building Department

💡 Pro Tips from Contractors

• Open footing holes for inspection BEFORE pouring concrete — this is the single most common deck inspection failure
• Submit complete plans upfront — missing ledger board details or footing depth is the #1 reason for permit delays
• In coastal or wet climates, use stainless steel hardware (hot-dipped galvanized minimum) — inspectors check this
• Check setback requirements from property lines before designing — some cities require 5-10 feet from property line

Notes specific to Aurora:

• Use online fee calculator: auroragov.org permit fee calculator
• Aurora requires mechanical contractor licensing (city-level)
• Spans 3 counties — one city permit office
• Colorado HVAC licensing required

❓ Frequently Asked Questions

🔗 Related Permit Pages

Other permit types in Aurora:

Deck permits in other Colorado cities:

More cities — Deck permits nationwide: